We will make a model that is smaller than the actual size. Based on the mockup, we will start full-scale production after verification with the customer.

(Mockups are manufactured when needed for meetings or verification)

Next, begins full scale shaping. We draw a front view and a side view on a large styrene block, and cut out the outline with heated wire.

Further shaping of the design by utilizing heated wire or knives.

Depending on the finish, refining work is performed to complete the prototype.

We then fill the holes particular to styrene with putty and finish the base. After that, we will move on to the work of water-based coating and urethane coating.